venturesjae.blogg.se - Icom 756 pro ii memory battery placement

The sub readout functions only during split operation or SWITCH

The sub readout frequency is displayed in outline or mesh font.

Selects the main or sub readout for access. 24)Ĭhanges the displayed frequency, selects set mode items, SWITCH

71, 73) Announces the selected readout frequency when an optional UT-102 is DIAL (p.

Functions vary depending on the operating SWITCH Įnters the ﬁlter set mode when pushed for 2 SWITCH Įxits from a set mode, etc.

Push to select the function indicated in the LCD display above these switches. (AM-D, FM-D) when pushed for 2 FUNCTION SWITCHES – Toggles RTTY and RTTY-R (RTTY re- CW/RTTY verse) mode when pushed for 2 sec.

Other manufacturer’s microphones have different pin assignments, and connection to the IC-756PRO may damage the transceiver. Use Icom microphones only (supplied or optional). This will avoid possible damage to the transceiver by ignition voltage spikes.ĭuring maritime mobile operation, keep the transceiver and microphone as far away as possible from the magnetic navigation compass to prevent erroneous indications.īE CAREFUL! The heatsink will become hot when operating the transceiver continuously for long periods.īE CAREFUL! If a linear amplifier is connected, set the transceiver’s RF output power to less than the linear ampliﬁer’s maximum input level, otherwise, the linear ampliﬁer will be damaged. Make sure the transceiver power is OFF before starting the vehicle. When transceiver power is ON and your vehicle’s engine is OFF, the vehicle’s battery will soon become exhausted. Place unit in a secure place to avoid inadvertent use by children.ĭuring mobile operation, DO NOT operate the transceiver without running the vehicle’s engine. Be aware that temperatures on a vehicle’s dashboard can exceed 80☌ (+176☏), resulting in permanent damage to the transceiver if left there for extended periods.ĪVOID placing the transceiver in excessively dusty environments or in direct sunlight.ĪVOID placing the transceiver against walls or putting anything on top of the transceiver. NEVER expose the transceiver to rain, snow or any liquids.ĪVOID using or placing the transceiver in areas with temperatures below –10☌ (+14☏) or above +60☌ (+140☏). RNEVER let metal, wire or other objects touch any internal part or connectors on the rear panel of the transceiver. This could cause a ﬁre or ruin the transceiver. RNEVER apply more than 16 V DC, such as a 24 V battery, to the jack on the transceiver rear panel. RNEVER apply AC to the jack on the transceiver rear panel. This may result in an electrical shock or burn.

RWARNING HIGH VOLTAGE! NEVER attach an antenna or internal antenna connector during transmission.